Cracked Hobie Bait Tank

[WARRIORMIKE]

So I recently just found out that a buddy of mine has a cracked bait tank. Is he better off buying a new one, or can these be molded back to place?

[Hunters Pa]

Where and how bad is the crack? Can plastic weld with a soldering iron. If the crack is bad he may need additional material

[Raskal311]

Depends on the crack but a slow leak is fine, just drill a hole at each end to stop the crack from progressing.

[bolocop]

MARINE TEX FLEX SET NON SAG PERMANENTLY FLEXIBLE EPOXY

[WARRIORMIKE]

Ok thanks gentlemen, I will see how bad the damage is tonight

[PescadorPete]

Mine cracked at the seam in the the front. Marine Goop inside and outside along the seam fixed it right up.

[WARRIORMIKE]

Mine cracked at the seam in the the front. Marine Goop inside and outside along the seam fixed it right up.

That's exactly where it's at

[makobob]

Drill a hole at both ends. Gorilla tape will do the job. Save your money.