Kayak maintenance

[Dee84cali]

Hey fellas i just purchased my first yak and used it twice. When I get home all I do is rinse it with my water hose. Is that all the maintenance it requires? I've also read online about applying WD-40 if so how often?


Sent from my iPhone using Tapatalk

[Kaleb]

What type of kayak?Do you have a Rudder and fins?

[Dee84cali]

X factor.. No rudder or fins


Sent from my iPhone using Tapatalk

[HobieScot]

Just rinse it down and make sure you check all the little nooks and crannies for blood.

Rinse all your gear, not just your kayak. Paddle, rods n reels, gaff and so on. One place I never thought to oil was where the two piece paddle connects in the center. Mine rusted up and made the button not snap into place so now I spray that down with corrosion x every time and it works again.

You basically just want to get the salt water and blood off of everything. Salt water corrodes everything


Sent from my iPhone using Tapatalk

[Rocketfish]

One place I never thought to oil was where the two piece paddle connects in the center. Mine rusted up and made the button not snap into place so now I spray that down with corrosion x every time and it works again.

Thanks for this tip! I never thought about that and have been using my paddles several times a week for 4 months now. I'm surprised that my paddle hasn't rusted up.

[Dee84cali]

Thanks fellas


Sent from my iPhone using Tapatalk

[Jimmyz123]

Hey fellas i just purchased my first yak and used it twice. When I get home all I do is rinse it with my water hose. Is that all the maintenance it requires? I've also read online about applying WD-40 if so how often?


Sent from my iPhone using Tapatalk

I have known some people that will use WD on the hatches so that they don't look faded from the sun. I've done it to help restore the look of the hatches, but it's not something that has to be done.

[YakDout]

This stuff is the bomb! I spray mirage drive, hatches, reels, anything really. Awesome awesome stuff.

http://www.amazon.com/Essentials-Silicone-Lubricant-Protectant-2-Ounce/dp/B003V6ZQR2

[Dee84cali]

What about that 303 aerospace protectant?


Sent from my iPhone using Tapatalk

[bluesquids]

The carry handles and other straps will deteriorate over time, the screws that hold them down will seize up really good by the time you want to replace them, some type of anti seize on them would be a good idea.

[bluesquids]

What about that 303 aerospace protectant?


Sent from my iPhone using Tapatalk
I use to put that on my yak often....i did it cause i also put it on my hot tub cover religiously...the cover got fried pretty good anyways. It probably works to some extent....I would just not leave it in the sun during storage.....yaks kept out on yachts for years fade and turn pretty brittle.

[Hunters Pa]

I was really expecting at least a couple smart-ass comments here.

[Dee84cali]

I was really expecting at least a couple smart-ass comments here.


Made it threw without a scratch... Lol


Sent from my iPhone using Tapatalk

[Hunters Pa]

The carry handles and other straps will deteriorate over time, the screws that hold them down will seize up really good by the time you want to replace them, some type of anti seize on them would be a good idea.

Good call. I had one seize up. Had to heat it with a soldering iron until the plastic around it melted enough for me to pull it out about 1/8 inch and get a wrench on the molded in nut that was spinning. Put in a new screw, reheated and was able to push it back in.

[HobieScot]

That Corrosion X Stuff works really well. I also spray it on my pliers, lip gripper, boat trailer, tow hitch and pretty much anything else I see rust on or expect to rust eventually.

It doesn't claim to be able to unstick rusted items but it does. I had a pair of pliers in a tackle box that I put away wet and forgot about for half a year that completely rusted shut. I was planning on throwing them away. But I decided to spray them with the corrosion x before I did. I let it sit for 24 hours and then tried to open them again. At first they barely opened. But after working them a bit they started working again. I still have and use those pliers. They look like hell but still work just fine.


Sent from my iPhone using Tapatalk

[HobieScot]

This is the stuf I use and swear by. I'm on my 2nd 6oz can in 15 years. This stuff lasts forever because you barely need to use any for it to work. And as they say "I put that shit on everything!" Anything metal on my fishing, spearfishing, boat, trailer, and dive gear gets a squirt. My dive knife especially. The dive knives all say that they don't rust but when you have it under water for hours and hours each day they all eventually rust. But a coating of this stuff keeps the rust off. On my dive gear all the little metal buttons/snaps used to rust and stop working. Then I sprayed them down after Every ten dives and they stay brand new.

[FlyFishinYakr]

What about that 303 aerospace protectant?


Sent from my iPhone using Tapatalk

I bought that stuff by the gallon (I think I still have about 1/2 gallon left) when I had a float tube and PAC 800 Pontoon boat. It kept them from fading to a minimum and because of the slick coating it seemed to help me glide through the water. It also reduced the slime/algae coating from some of the lakes I've fished which I hope will do the same for my kayak (or rather oil and tar balls up here)!.
As with my reels during the season or between servicings I use this to keep screws and bolts from freezing or corroding also (along with Corrosion X) ;
http://www.amazon.com/s/ref=nb_sb_ss_i_3_9?url=search-alias%3Dsporting&field-keywords=breakfree+clp+gun+cleaner&sprefix=Breakfree%2Csporting%2C402
I was introduced to this cleaner when I was working in a tackle shop and trained how to properly service reels, it seemed to help frozen screws and bolts when soaked overnight.
FFY :sifone:

[HobieScot]

I bought that stuff by the gallon (I think I still have about 1/2 gallon left) when I had a float tube and PAC 800 Pontoon boat. It kept them from fading to a minimum and because of the slick coating it seemed to help me glide through the water. It also reduced the slime/algae coating from some of the lakes I've fished which I hope will do the same for my kayak (or rather oil and tar balls up here)!.
As with my reels during the season or between servicings I use this to keep screws and bolts from freezing or corroding also (along with Corrosion X) ;
http://www.amazon.com/s/ref=nb_sb_ss_i_3_9?url=search-alias%3Dsporting&field-keywords=breakfree+clp+gun+cleaner&sprefix=Breakfree%2Csporting%2C402
I was introduced to this cleaner when I was working in a tackle shop and trained how to properly service reels, it seemed to help frozen screws and bolts when soaked overnight.
FFY :sifone:


Good call on the CLP. That's another product I use. It's designed for the firearms industry and its what I use on all my guns for hunting season. I never thought to use it on fishing gear.




Sent from my iPhone using Tapatalk

[SASQUATCH]

A great solution for stuck bolts/ rusty hardware is 50% acetone and 50% transmission fluid. Was tested against all the top brands of break free solutions and beat them hands down. I've used it many times and swear its the only way to go. Way less expensive too. Try it, you'll be a believer.

[YakDout]

Just don't put that on plastic.

[Dee84cali]

This is the stuf I use and swear by. I'm on my 2nd 6oz can in 15 years. This stuff lasts forever because you barely need to use any for it to work. And as they say "I put that shit on everything!" Anything metal on my fishing, spearfishing, boat, trailer, and dive gear gets a squirt. My dive knife especially. The dive knives all say that they don't rust but when you have it under water for hours and hours each day they all eventually rust. But a coating of this stuff keeps the rust off. On my dive gear all the little metal buttons/snaps used to rust and stop working. Then I sprayed them down after Every ten dives and they stay brand new.


I'm gonna jump on this. Thanks


Sent from my iPhone using Tapatalk

[HobieScot]

You are welcome!

I've been using it for years and there is nothing metal that it doesn't work on.

It's also what I spray on my mirage drive

It repels water so it keeps salt water from penetrating

It's also supposed to work for electronics. One of their adds show a TV that had all the electronics dips in their solution then placed in an aquarium full of water as their commercial played.

I don't know if I would trust it that much but I did spray all my electrical connections on my trailer and it stopped rusting and the electrical problems I was having with the break lights 👍🏼

It would be a good product to spray on the electrical connections for a bait tank or fish finder. It would help keep the salt water out


Sent from my iPhone using Tapatalk