Kraken-----

[MITCHELL]

Anybody no where I can gets some blue welding rod.

[MITCHELL]

No more

[kirkdavis]

Now you have red white and blue. Go USA!

[MITCHELL]

Buddy

[Reiner]

It's a fishing website. Keep your political BS to yourself and off the forum.

[MITCHELL]

Its called freedom....don't like what you see move along :the_finger:

[Hunters Pa]

I like the metal mesh reinforcement. What is the beige paste, glue? I have welded my share of cracks, but using a soldering iron and zip ties or trimmings from previous installs for material

[MITCHELL]

I don't no about any glue. But it works good, its was a cold day and I used a heat gun to. I have used harbor freight plastic welders and this works way better. It's best if you melt the mesh into kayak. There's no wasting of plastic rod. Holding plastic on the side does not work as well and takes for ever as apposed to pushing round rods down the center.

[MITCHELL]

Clear probably doesn't show as bad maybe ill see if they fit through the hole in my iron.
Before I got the hobie welder, I patched my canoe heating up a butter knife with a propane torch, and put mesh that got the job done to, it was like cauterization of a wound and flattened out some bumps.

[Hunters Pa]

Clear probably doesn't show as bad maybe ill see if they fit through the hole in my iron.
Before I got the hobie welder, I patched my canoe heating up a butter knife with a propane torch, and put mesh that got the job done to, it was like cauterization of a wound and flattened out some bumps.

Save any trimmings from installs of hatches or whatever. can also trim thin strips from inside underneath the hatch.

[MITCHELL]

It's thick and melts slow I thought about cutting it into strips I found my tin snips after I finished the job.
By the way best duck tape ever made is 622 shurtape I personally used to use it to mask new windows on building's. Put it on one time and take it off after finish. No glue residue from tape