-scallywag-
12-22-2010, 01:48 PM
I was out on a particularly foggy day recently and was scrolling through some of the screens when I saw this......:eek:
http://www.bigwatersedge.com/bwegallery/data/500/P1010197.JPG
I used this FF head for a full season a few years ago, before upgrading to a higher wattage, dual beam Hummingbird without GPS which uses the same mount and transducer. Since then I only use this head for GPS when fog is an issue.
I also want to say thanks to Fastlane and HOBIE. As one can imagine, hundreds of surf launches/landings and a thousand+ miles of ocean travel (I don't fish fresh/bays) can be pretty hard on equipment. But to be honest the failures have been very minimal. Mostly V1 sprockets/turbo masts which has since been fixed with the introduction of the V2 sprockets/masts (I have not broken one of those yet).
Recently I had the drive-well crack (where the fins snap into the hull) on my 06 Revo, a quick trip to Fastlane and less than 24hrs later I was in Oceanside getting a quick tour of the manufacturing process, checking out the new OASIS tandem, and picking up my fresh 2011 Revo hull.
THANK YOU, FASTLANE and HOBIE !!!!! :you_rock:
So....how many miles on your yak?
http://www.bigwatersedge.com/bwegallery/data/500/P1010197.JPG
I used this FF head for a full season a few years ago, before upgrading to a higher wattage, dual beam Hummingbird without GPS which uses the same mount and transducer. Since then I only use this head for GPS when fog is an issue.
I also want to say thanks to Fastlane and HOBIE. As one can imagine, hundreds of surf launches/landings and a thousand+ miles of ocean travel (I don't fish fresh/bays) can be pretty hard on equipment. But to be honest the failures have been very minimal. Mostly V1 sprockets/turbo masts which has since been fixed with the introduction of the V2 sprockets/masts (I have not broken one of those yet).
Recently I had the drive-well crack (where the fins snap into the hull) on my 06 Revo, a quick trip to Fastlane and less than 24hrs later I was in Oceanside getting a quick tour of the manufacturing process, checking out the new OASIS tandem, and picking up my fresh 2011 Revo hull.
THANK YOU, FASTLANE and HOBIE !!!!! :you_rock:
So....how many miles on your yak?