Kayak Fishing Adventures on Big Water’s Edge

Kayak Fishing Adventures on Big Water’s Edge (http://www.bigwatersedge.com/bwevb/index.php)
-   General Kayak Fishing Discussion (http://www.bigwatersedge.com/bwevb/forumdisplay.php?f=11)
-   -   Ye Ol Live Well Bait Tank (http://www.bigwatersedge.com/bwevb/showthread.php?t=14673)

AM3R1CN 08-04-2012 05:03 PM

Ye Ol Live Well Bait Tank
 
Hi Kayak Angler Folks

I'm interested in making a bait tank for saltwater (ocean) kayak fishing, as all new kayak fisherman must do.

Could one just use the existing scupper holes in their kayak and put a couple pvc/rubber tubes through the scupper holes (as long as there were extra scupper holes available) and seal them so the water could only go up through the holes (with one way directional valves, water goes in only) into the bait tank and overflow water drains out the top of the bait tank. Wouldn't this be an incredibly simpler version of this whole bait tank design fiasco with aerators, batteries etc?

Wouldn't the simple rocking back and forth of the boat through waves be enough to push water up through these valves and keep fresh oxygenated water in the live well?

THANK YOU!
:you_rock:

Cbad Mike 08-04-2012 05:23 PM

Interesting concept but I doubt it would work. Scupper holes are made to let water out. There is not enough pressure of water that comes in them. If there was water would shoot up them like a geyser and I sure hope that's not happening on your kayak.
Just my opinion.

yakman619 08-04-2012 05:51 PM

Quote:

Originally Posted by Cbad Mike (Post 128009)
Interesting concept but I doubt it would work. Scupper holes are made to let water out. There is not enough pressure of water that comes in them. If there was water would shoot up them like a geyser and I sure hope that's not happening on your kayak.
Just my opinion.

^ X2

bus kid 08-04-2012 07:08 PM

Google hobie bait tank:rolleyes:
Look in the innovations thread.
Search feature is your friend.

AM3R1CN 08-04-2012 11:51 PM

Quote:

Originally Posted by bus kid (Post 128030)
Google hobie bait tank:rolleyes:
Look in the innovations thread.
Search feature is your friend.

or you could provide a link since this poem was completely unhelpful. :rollseyes:

bus kid 08-05-2012 06:29 AM

Quote:

Originally Posted by AM3R1CN (Post 128061)
or you could provide a link since this poem was completely unhelpful. :rollseyes:


http://bit.ly/Ncn6fE

http://www.bigwatersedge.com/bwevb/s...archid=1098352

http://www.bigwatersedge.com/bwevb/s...archid=1098354

there you go. Now do you want me to paddle you out, tie all your knots, cast for you reel in the fish fillet it abd drive you home too, after I build the tank. :rolleyes:
oh btw ( that means By The Way) Welcome to Bwe

MrPatrick 08-05-2012 07:40 AM

Replies
 
AM3R1CN be prepared for some ball bustin' on this site. 99.9% of it is done in fun. We will all help you out..................... Whithin reason.:cheers1:

berkeley.william 08-05-2012 08:10 AM

i have one 90% built already it just needs a battery and battery box. if you are interested let me know it is a 50 quart tank. i started to build it but just haven't finished it. i will sell the whole thing for $75

AM3R1CN 08-05-2012 01:07 PM

Quote:

Originally Posted by bus kid (Post 128069)
http://bit.ly/Ncn6fE

http://www.bigwatersedge.com/bwevb/s...archid=1098352

http://www.bigwatersedge.com/bwevb/s...archid=1098354

there you go. Now do you want me to paddle you out, tie all your knots, cast for you reel in the fish fillet it abd drive you home too, after I build the tank. :rolleyes:
oh btw ( that means By The Way) Welcome to Bwe

learn to read before you post a response. the question was will the concept work? the question wasn't are you a prick? which you affirmed twice with a YES!

I am wondering if i drill a hole in the bottom of a storage bin and connect a couple pvc or rubber pipes with omni directional water flow valves ie IN to the container and OUT of the container can i create the circumstances necessary to keep fish alive without buying a $300 dollar container.

:the_finger:
oh btw GTFOH (that means Get the Fk Outa Here)

MrM 08-05-2012 01:18 PM

AM3R1CN-

This reply is just a "heads up"....


Recently, we had a lot off people on here who were, well, un-helpful. You can read about that here. (also stickied at the top of this forum) Comment's such as your last might rub those in power the wrong way.

However, it goes without saying in any forum, that the search function is your friend (especially when your post count is less than 5)

We're a friendly community, I promise. Some of us are seasoned vets, and some are still noobies. Just get to know us before you start telling us where to shove it. You'll get more help that way.


To answer your question, I've never seen it done that way when homemade, but there are plenty of us who use the OEX bait tanks, or even made them ourselves (myself included). It would be an interesting idea to use the scupper holes, and it might look pretty clean. Just make sure you measure twice, cut once- and with a little luck it'l look great. As for the inner workings, the one way valves might be a little tricky. Honestly, I don't think you need to reinvent the wheel on this. It sounds like you'd spend a lot of time and effort on building something that can be done much easier and cheaper with a much more common set of plans.

Either way, best of luck to you, and I hope it turns out good. Keep us posted.

bus kid 08-05-2012 02:07 PM

Quote:

Originally Posted by AM3R1CN (Post 128132)
learn to read before you post a response. the question was will the concept work? the question wasn't are you a prick? which you affirmed twice with a YES!

I am wondering if i drill a hole in the bottom of a storage bin and connect a couple pvc or rubber pipes with omni directional water flow valves ie IN to the container and OUT of the container can i create the circumstances necessary to keep fish alive without buying a $300 dollar container.

:the_finger:
oh btw GTFOH (that means Get the Fk Outa Here)

,

I did that's why I told you to look at the hobie bait tank 1st, its set up thru the scuppers but uses a pump, why a pump because the h20 has to circulate to keep the bait alive, no you will not be able to generate enough force with a moving kayak to overfill a bait tank unless you tank is 32 oz or less.

2nd in the innovations thread there are plenty of bait tanks even a few that were built for well under $100. That perform as well or better then the $300 I built mine and have everything from squid, macs dines, chovies and even a calico all survive a days trip 8 plus hours The key is water flow. Good luck with your tank, and hopefully you learned something today.

Fiskadoro 08-05-2012 02:12 PM

Quote:

Originally Posted by AM3R1CN (Post 128132)
learn to read before you post a response. the question was will the concept work?

The answer is NO! It won't work!!!

What your thinking is the inertia of the mass of the water in the scupper will essentially overcome the gravitational pull of the water in the tank, but your dreaming that water will run up hill.

Nice idea, but like perpetual motion machines no matter how good it sounds to you it's no going to work because physics is based simple realities that are not influence by imagination, hallucinations, or dreams.

If you had a ridiculously shallow tank maybe an inch deep this idea might work to an extent but unfortunately for you sea water increases pressure 0.44 psi per foot of depth and at a little over a depth of two inches you'll have a increase of almost 0.1 psi which will no longer allow your scupper valve to open. I can't calculate the exact psi increase you get in a scupper as a yak rocks but I can tell you with relative certainty it is not equal to 0.1 psi, so basically your shit out of luck after your tank fills an inch or two.

This reminds me a friend of mine who came up with a zero power bait tank for his skiff.

Since he was always slow trolling he surmised that if he had a forward facing intake with a one way valve that as he trolled at say 3 knots water would be pushed through the valve and fill the tank. In actual use when running at 20 knots the tank filled fine, but at 3 knots it only filled to about four inches.

Maybe four inches is enough for you, (we all have different standards) if so you can run a forward facing pvc 90 through your scupper and paddle like hell to fill your tank to four inches. Anyone whose stuck their hand in the water when traveling three knots knows that there is some push to water at that speed, that said it will not fill your tank, and it's moving a hell of faster with more energy in relationship to your yak then water boobing up a scupper.


In other words nice try but no cigar. If you want some information on systems that actually work just say so. People will be more then happy to help you.

If not let me suggest a bait tube, not brain surgery, and they almost always work, if you can figure out how to make caps with holes in them for the ends.


Quote:

Originally Posted by AM3R1CN (Post 128132)
the question wasn't are you a prick...........oh btw GTFOH (that means Get the Fk Outa Here)

AgroAM3R1CN who could of seen that coming :D

I will say you win the prize for the most entertaining post of the day.

:party::party:

AM3R1CN 08-05-2012 02:41 PM

Quote:

Originally Posted by Fiskadoro (Post 128138)
The answer is NO! It won't work!!!

This reminds me a friend of mine who came up with a zero power bait tank for his skiff.

Since he was always slow trolling he surmised that if he had a forward facing intake with a one way valve that as he trolled at say 3 knots water would be pushed through the valve and fill the tank.

In actual use when running at 20 knots the tank filled fine, but at 3 knots it only filled to about four inches.

Ha! great! that was gonna be my next question.

Well i did see a post here:
http://www.tightlinesandplasticboats...en-system.html

this logic is interesting, but is it just one guys opinion or is this real? can you just add oxygen from a tank to the water with an air stone? and not need to circulate water? Or does this work on fresh water bait only?

TY

bus kid 08-05-2012 03:30 PM

Quote:

Originally Posted by AM3R1CN (Post 128151)
Ha! great! that was gonna be my next question.

Well i did see a post here:
http://www.tightlinesandplasticboats...en-system.html

this logic is interesting, but is it just one guys opinion or is this real? can you just add oxygen from a tank to the water with an air stone? and not need to circulate water? Or does this work on fresh water bait only?

TY



Here Ty let me widen your horizon, a bait tank is nothing more than a temporary aquarium so if you build it with that in mind you will be ok. Here's a link to help you since you seem to still be a little confused.

http://www.aquariumguys.com/aquarium...n-article.html

AM3R1CN 08-05-2012 09:33 PM

Quote:

Originally Posted by bus kid (Post 128153)
Here Ty let me widen your horizon, a bait tank is nothing more than a temporary aquarium so if you build it with that in mind you will be ok. Here's a link to help you since you seem to still be a little confused.

http://www.aquariumguys.com/aquarium...n-article.html

Well now that was quite helpful

thank ye

(TY means Thank You)
:luxhello:

Bassassin 08-06-2012 12:53 PM

Quote:

Originally Posted by AM3R1CN (Post 128151)
Ha! great! that was gonna be my next question.

Well i did see a post here:
http://www.tightlinesandplasticboats...en-system.html

this logic is interesting, but is it just one guys opinion or is this real? can you just add oxygen from a tank to the water with an air stone? and not need to circulate water? Or does this work on fresh water bait only?

TY

Hello Ty I am the author of that link... I do not know if this techniqe will work for salt, however the in my humble opinion it should. For fresh water Striped Bass fishing it is very hard to keep Blue Back Hering alive, with this system they stay alive all day in the hot sun while the guys with 5 gal buckets and bubble boxes have them dying off within hours. We can not pump the fresh water into the tank as the temp of the surface water is in excess of 85 degrees f. this will kill the bait quickly. BTW this system is sold to fisherman and used exclusively by the guides on most of the fresh water lakes in Georgia.

Tight lines,
Walt

kareem korn 08-06-2012 01:18 PM

If the tank is above the water line No.
You need a pump than.
Or a hand squeeze pump. This will require manually pumping water in every couple of minutes.

dorado50 08-06-2012 02:43 PM

This is not rocket science here,wtf....think outside your box dude.:confused:

Divad 08-06-2012 03:21 PM

Cheap & Simple Bait Tank
 
1 Attachment(s)
If you don't want to spend alot of money try a bait tube.

bus kid 08-06-2012 03:55 PM

this thread is on it's way to KNOTLESS hook status!!! :the_finger:


All times are GMT -8. The time now is 01:54 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
© 2002 Big Water's Edge. All rights reserved.