Line rigging fix-it tip needed to rerig Revo 13 rudder keeper
 

The rudder keeper bungee loops out of a fitting on the Revo stern. (Circled in yellow) My line has become frayed and I need to replace it.

I've got the line and would welcome and rigging tips. What's the tip to "open" or access the fitting that the stern buggee comes out of?

Do you access it by a twist of the fitting, or work at the fitting from inside from the rear hatch? I could not get my head in there.

Or, is the line just knotted inside?

I'd welcome any tips prior to poking at it.

http://www.bigwatersedge.com/bwegall...3/kayakfix.jpg

It will unscrew from the outside of the kayak. When it is off, simply thread the bungee through the hole, tie a knot on the backside, screw it back in an you are good to go.

Hobie makes a tool to unscrew them

http://i35.photobucket.com/albums/d1...eorr/39507.jpg

I've never used the tool. Needle nose pliers have always worked well for me. :cheers1:

I figured it was simple, but figured it better to ask than blindly twist away. Thanks.

Just like Steveooo said, long nose pliers work just as good as that tool.

Saws all. :D

Use a torch to heat up the fitting to loosen it! :D