The new rack system and kayak all rigged up.
 

Just wanted to post some pics of my new rack system and my kayak all rigged up.
Im actually pretty proud of the rack. Made it myself.

Attachment 8739

Attachment 8740

Attachment 8741

Attachment 8742

Attachment 8743

Nice job
 

nice one. I like how you put enough space to be able to open the tail gate..

That way my main reason for doing the hitch like this. My rods/gear wont fit in my cab so I have to have the bed operable and able to store stuff.



Yea the way the racks are it would be impossible,kinda like this \____/, It squeezes it from both sides so it cant slide backwards or forwards. Also the point of the kayak would hit the trim of the cab right above the window. That was my big worry when making it. That bar going up and down has a few holes in different positions of height incase I want to raise it more.

Nice rack...
Did you consider making the forward support taller and going over the cab to reduce your overhang (Kayak at an angle)? Also, can you go over how you load the kayak onto the rack? I am guessing you prop it onto the rear support then climb in the bed and load it the rest of the way. I am asking because I am interested in a similar rack for a short bed pickup with a tonneau cover. My idea would be to use a similar rear support and use a yakima/thule bar either on top of the cab or directly on the tonneau cover. I was worried if I put it on the cab when sliding the kayak up it would be a PIA because it would want to pivot over before the tip reached the cab (12 ft kayak)

I have the option to raise the front support if needed (longer kayak in the future) but for now it only overhangs about 3 feet Im guessing from the back. I like the look of it when its level and also the less wind resistance the better.
The way I load it is I put the kayak on the kayak cart, load the front of the kayak in the bad, take the cart off, tilt from the back to get it in the front holder and then lift the back in to the back rack with an overhead lift. Im not sure if this specific rack will work for your application since the kayak is tapered and will wedge itself in the angle of the rack.
I dont reccomend the over the cab since you will be getting a lot of wind resistance plus overhead stuff might hit but if that is your only option, and you dont mind drilling or welding to your cab, then do it! lol
It is going to take a lot of downward force to get it in the front rack via loading from the back rack, like you said.

Have you thought about a bow notch like they have for boat trailers to keep your
Yak from sliding through the back window?
Otherwise Kudos & Props for the rack :notworthy:, and that's a great set-up for the Yak also. :reel:
FFY.

Nice rack dude. it looks sturdy and it should get you to and from the water. good job

Nice setup! I'm building a similar livewell/drybox out of a vittles vault. Just wondering why yours is set with lid pointing towards the back? Is it hard to reach back there?

Bait tank is open facing the front. The lid is just hanging loose over the back.

:doh: I see that now...