Kayak Fishing Adventures on Big Water’s Edge

Kayak Fishing Adventures on Big Water’s Edge (http://www.bigwatersedge.com/bwevb/index.php)
-   General Kayak Fishing Discussion (http://www.bigwatersedge.com/bwevb/forumdisplay.php?f=11)
-   -   Dent in bottom (http://www.bigwatersedge.com/bwevb/showthread.php?t=2432)

out of reach 08-12-2007 08:36 PM

Dent in bottom
 
Borrowed the folks hobie tandem to take the nephew out and noticed it has a 1' x 1' dent in the bottom. Took it out and it has quite a list :rolleyes:. It it now trash?? If I pop it out is it only safe for knee deep water?? The dent has probably been there for a year or so. Any warrenty for that type of thing??

Siebler 08-12-2007 08:50 PM

Try popping it out, If it doesnt want to pop then Turn it upside down and tape a black trashbag over it and let it sit in the sun for a few hours, Then try it again. Should pop right out.

jscott 08-13-2007 07:44 AM

if that doesn't work-- try a hairdryer or better yet a heat gun if you have access to one. Once you warm it up-- it should pop right out. I did this on my 'found' malibu 2. It had a big dent in the bottom. Popped right out and I have been on it with the family (wife and daughter) a few times now.

Billy V 08-13-2007 07:19 PM

Place the Yak "Hull Side Up" in the sun for a couple of days.
Be sure to open the drain plug. That should be enough to allow the roto poly to return to normal.

I've seen a flat spot removed from my neighbors Adventure when he left the yak stored on the yak cart inserted in the scuppers.
------------------


All times are GMT -8. The time now is 09:04 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
© 2002 Big Water's Edge. All rights reserved.