I wouldn't even do it the way that dude on the video does it unless I wanted to possibly damage the original hole. I use a bigger drill bit, like 3/16" or 1/4", and just drill until the top comes off or just deep enough that any roll or burr on the top of the shaft is completely gone. Then use a punch or whatever to push the remaining rivet through.
__________________
Hobie PA 14 ¸.·´¯`·.´¯`·.¸¸.·´¯`·.¸><(((º>
Jackson Kraken ¸.·´¯`·.¸.·´¯`·.´¯`·.¸¸.·´¯`·.¸><(((º>
Malibu X-Factor ¸.·´¯`·.´¯`·.¸¸.·´¯`·.¸><(((º>
Malibu Stealth-12 ¸.·´¯`·.´¯`·.¸¸.·´¯`·.¸><(((º>
Its not a spelling B its a fishing B ~yakjoe
|