No problem...
Scotty sells two kinds of flushmount. I use the 244L right now - it locks the rod holder in place, since I use Orcas. The actual locking pin on the 244L seems flimsy and weak, but it's been holding up. The bottom of the 244L is empty so you have to cap-it if you go this route.
One last thing: be aware of the rudder lines below when you are installing the flushmounts. Good luck.
Below is a picture of the 244L on my Outback. Andy at OEX installed these.
244L:
http://www.kayakfishingsupplies.com/...eck-mount-244l