View Single Post
Old 12-23-2016, 01:06 PM   #8
Deamon
Senior Member
 
Deamon's Avatar
 
Join Date: Mar 2010
Posts: 1,972
Hey Ojos,

I've had a Revolution and now have a PA. And I'm assuming you'll have your bait tank in place too. So depending on the size of your fish regardless of variety...They will not go inside on any Hobie rear hatch. You could strap them one on each side of the bait tank but you'll prob need help doing it. Def helps to have as much weight in the back as possible. Regardless, if you have this situation, it's a good one to have. I place them on the inside between the hull and the drive. You might rub a part of the fish cause it can get tight right there. Then you're heavy in front and if you're landing in any kind of surf...tie everything down, lol. I have also pulled the mirage drive, place them all in front and paddled in. On the pic below, surf was decent, I jumped out, held on to the stern handle and rode it in. Hope this helps brotha.

Jim
Attached Images
File Type: jpg IMG_1593.jpg (71.3 KB, 92 views)
__________________
Recreational Fisherman's Catch...2%
Commercial Fisherman's Catch- 98%
Recreational Fishing Kayakers Catch- .00001%
"The reality is that the wall was built to keep all Asians ~specifically Japanese and those that think they're japanese~ out of the U.S"


Last edited by Deamon; 12-23-2016 at 02:47 PM.
Deamon is offline   Reply With Quote