Kayak Fishing Adventures on Big Water’s Edge - View Single Post

Mahigeer · 01-30-2014, 01:46 PM

My suggestion would be Not to glue the unit like one would do when assembling PVC for water pressure.

Everything has to line up, so any misalignment is permanent and it will cost money to replace or start over again.

I have built rod holders with many connectors and angles. First I assembled the unit, then once happy with the unit, I used a small brush to apply PVC glue to the edge of the connector. It worked fine.

Good luck.

01-30-2014, 01:46 PM	#437
Mahigeer Senior Member Join Date: Apr 2013 Location: Los Angeles Posts: 1,863	My suggestion would be Not to glue the unit like one would do when assembling PVC for water pressure. Everything has to line up, so any misalignment is permanent and it will cost money to replace or start over again. I have built rod holders with many connectors and angles. First I assembled the unit, then once happy with the unit, I used a small brush to apply PVC glue to the edge of the connector. It worked fine. Good luck.