Built my GT drive today. A couple things that were a PITA were the needle bearings in the sprockets due to their length. I ended up pulling every pin from every bearing to fill will some marine grease. Actually wasn't as bad as I thought it would be. The chains fought me for a bit too. This was my first time doing anything to a mirage drive and I felt it was time to learn what I'm using. Thank you LIPRIPPER for the write up. Followed it and it worked to a tee. And thank you ICEMAN and OEX Sb for the parts. Will follow up once tested on water.
ImageUploadedByTapatalk1422159892.320234.jpg