|
After visiting OEX Mission Bay and seeing it in person, I can say that the promar nets will not fit behind the engine - unless you devise some sort of special holder for them to mount them vertically - and then raising the outboard cant be done because they would be in the way.
But, there are square acres out front - much more room than a PA14. Some sort of holder can be devised to stack them flat up there easily.
I've found out that the only way to mount a transducer is off a bracket, either mounted using a transom mount, or better, using a ram clamp on the rear grab bar so it can be folded up and out of the way for transport. Another option would be to just use one of the ram arms that go over the side - that could easily be swung up and out of the water while underway. Inside mounting is a no-go because of the foam. It was suggested that it could be possible to carefully carve away a pocket down to the hard hull to mount one, but not advised.
|