Quote:
Originally Posted by senojmj
That is good to know. I always wondered how outrigger canoes worked and didn't tip on the side without the outrigger. I haven't tried using a heat gun on pvc. Can you just bend it once heated? Any ideas how to get both poles to have the curvature? I think I will have to practice a bit. Thanks for the feedback!
|
I was thinking that was black ABS, but both will bend.
What you want to do is get it on a clean surface and roll it back and forth while moving the gun up an down the length of it. The idea is to get it all hot evenly and then when it gets flexible make one bend full length one time.
Wear gloves as it's hot.
To make the second one the same: lay the first on down next to the second one right when you get it ready to bend and use it as a pattern, or just cut an exact pattern of the bend out of cardboard, don't use it as a form but more of a guideline.
Jim