|
Nice install Jim. Thru hull is the way to go just be sure to use the fast cure 5200 (which you can also get in white). The regular stuff can take a month to cure. My only question is why you did not use SS counter sunk bolts with SS fender washers and nylock nuts on top instead of screws? Not that I think you would have any issues with screws but curious what went into that decision. I have built and rigged many skiffs and was just wondering. My yak is old school with no FF since I don't use it very often.
Good 5200 story, I had to torch and sledge hammer out my last bronze transducer which I used 5200 to install (it failed) in my boat. I have drilled 7 thru holes in my boat and none leak. I once had to use a forklift to get an engine bracket off a boat that was adhered only with 5200 (bolts removed)!
|