Kayak Fishing Adventures on Big Water’s Edge - View Single Post

james92026 · 11-21-2011, 12:53 PM

copied design from another blog (Palmetto). Excellent instructions with step by step photos. Works great EXCEPT using a 10.5 Inch top support is a little narrow for this particular boat and positions the cart a little too far aft which is not a problem but having the width about 4 to 6 inches wider would enable you to cradle the hull better and more towards the middle/balance point. Having the cart that far back, the tie straps kept sliding back should I happen to lock a wheel in an obstacle. I solved the problem by taking two tie straps from each side of the axel and ran them up to the bow handle, (nothing to buckle, just hold on to the straps) this keeps them taut and the cart does not slide off. A great little project for a cart that comes apart to store in an "A" hatch. and costs about $33 to build. just a FYI....

11-21-2011, 12:53 PM	#186
james92026 Senior Member Join Date: Nov 2011 Location: Escondido CA Posts: 114	PVC Kayak Cart for Cobra Navigator XF copied design from another blog (Palmetto). Excellent instructions with step by step photos. Works great EXCEPT using a 10.5 Inch top support is a little narrow for this particular boat and positions the cart a little too far aft which is not a problem but having the width about 4 to 6 inches wider would enable you to cradle the hull better and more towards the middle/balance point. Having the cart that far back, the tie straps kept sliding back should I happen to lock a wheel in an obstacle. I solved the problem by taking two tie straps from each side of the axel and ran them up to the bow handle, (nothing to buckle, just hold on to the straps) this keeps them taut and the cart does not slide off. A great little project for a cart that comes apart to store in an "A" hatch. and costs about $33 to build. just a FYI....