View Single Post
Old 05-01-2013, 08:18 AM   #18
Honcho
Senior Member
 
Honcho's Avatar
 
Join Date: Mar 2013
Location: Carlsbad
Posts: 101
Quote:
Originally Posted by RockyRaab View Post
I was never able to get the post clamps tight enough to support my fully-loaded Prangler 14. So I cut two pieces of PVC that just fit over the cart tubes - and then two more pieces of PVC that just fit over the first ones, making them twice as thick. I put them on under the post clamps, so the PVC rests on the axle and supports the clamps. I carefully measured the cart posts so that with the PVC spacers installed I still had room to insert the keeper pin into the post top.

Other folks have simply replaced the post clamps with a tennis ball, but that may or may not allow you to still use the keeper pin.
I am so visual..Can you post some pictures? thanks!
Honcho is offline   Reply With Quote