|
I just purchased a dragonfly at Christms. I am using pvc over the side. I used a foam plug into the Outback cup holder. I compress the foam with big washers and a nut. The bolt is a couple inches longer than flush so i drilled a hole is a cutting board and slide it onto the bolt. I used butterfly nut to tighen the cutting board to the foam insert and hobie deck. I then mounted the FF display to the cutting board. The over the side arm is locked with a removable pin so when not using the FF, i rotate the arm 90 degrees and out of the water. I can sent you pics if you want.
Good luck
|