Bait Tank

[MrM]

As promised..


Make sure you goop up every single hole you make! If I was to do this again, I would remember to drill through the rubber insert and thread all of the wiring first. I forgot to do it for the wires running to the pump, and had already soldered/heat shrunk everything through the plastic (minus the rubber), and didn't want to re-do all that work again.

Just remember, the switch lays on the hot line. The negative runs straight to the battery. Measure twice, cut once. And solder away!


Edit- Darth, if you wanted to run a fuse, put it between the switch and battery on the hot line. That way it will save everything if you have a short. I don't think you'll need one, but I'll let you make that call.