PA 12 and Outback new option

[bus kid]

Originally Posted by TJones

this conversion will not work on revolution? revo no deep enough i would imagine? to convert you cut out old hatch?

The revo is not wide enough and the contour of the area where the round hatch is would not fit the hatch as its flat. You could however install it in the back length wise.
My concern with the conversion for the out back is the structural integraty of the top deck after you remove all the surface area

[Iceman]

the structural integraty of the top deck after you remove all the surface area

This would be a problem...........if you cut the hole and then did not install the hatch

[JNAST13ST]

How much would it cost to ship it down to San Diego?