Scupper hole mount transducer? - Kayak Fishing Adventures on Big Water’s Edge

Lipripper92592 · 01-12-2013, 08:43 AM

I have one hooked up to a DSI transducer and it fits pretty well. Didn't use the star shaped neoprene washer as it pushed the transducer past the hull. Pretty pricey for a bit of plastic, but its pretty hard to make a custom mount because of the need to fabricate the fingers to fit in the groove on the ducer.

IMG_0567 by lipripper1, on Flickr

IMG_0568 by lipripper1, on Flickr

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

01-12-2013, 08:43 AM	#5
Lipripper92592 Senior Member Join Date: Dec 2012 Posts: 516	I have one hooked up to a DSI transducer and it fits pretty well. Didn't use the star shaped neoprene washer as it pushed the transducer past the hull. Pretty pricey for a bit of plastic, but its pretty hard to make a custom mount because of the need to fabricate the fingers to fit in the groove on the ducer. IMG_0567 by lipripper1, on Flickr IMG_0568 by lipripper1, on Flickr