lowrance sucks

[icelogger]

I picked up the Elite 7 last week. I'm waiting on my battery from OEX which should arrive tomorrow to install it in my new PA. I will test this issue as soon as I can and reply back. I will be doing the through hull duct seal mount until I figure out how to install the 83/200 on the new lorance ready mount in the hobie pro angler(which was not designed for the 83/200 by the way)

I too bought this unit for depths greater than 100 ft. Even though I don't pay much attention to the amplitude of the waveform for interpretation, this should of been worked out in R&D if that's the case.

What type of transducer mount are you using? Could your ducer mount have anything to do with this issue.

[salty pirate]

Originally Posted by icelogger

I picked up the Elite 7 last week. I'm waiting on my battery from OEX which should arrive tomorrow to install it in my new PA. I will test this issue as soon as I can and reply back. I will be doing the through hull duct seal mount until I figure out how to install the 83/200 on the new lorance ready mount in the hobie pro angler(which was not designed for the 83/200 by the way)

I too bought this unit for depths greater than 100 ft. Even though I don't pay much attention to the amplitude of the waveform for interpretation, this should of been worked out in R&D if that's the case.

What type of transducer mount are you using? Could your ducer mount have anything to do with this issue.

83/200 455/800 ducer. it is mounted to the lowrance ready mount on pa12. I had no problem installing the transducer.