Kayak Fishing Adventures on Big Water’s Edge  

Go Back   Kayak Fishing Adventures on Big Water’s Edge > Kayak Fishing Forum - Message Board > General Kayak Fishing Discussion

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 08-20-2013, 11:02 AM   #6
pbb
Senior Member
 
pbb's Avatar
 
Join Date: Jul 2013
Location: San Diego
Posts: 149
Thanks for all the feedback. It is loosely based on the Palmetto PVC cart, but again I was eyeballing the width in my original cuts.

I might take the yak down and give a trial run in the yard at the current width before gluing everything together or deciding to cut it narrower to fit into the channels.

I didn't want to put posts for the scupper holes, b/c I saw (on youtube) that some folks turn their carts upside down on their cars and use them to load onto the racks. But I suppose I could consider putting posts that wouldn't be glued in and thus could be removed for car loading.

I'm using Lowe's 7 inch plastic wheels, which are fairly narrow (1.5"). It just occurred to me that I could buy a second pair of wheels to increase the width of both the wheel surface and the overall cart: A dually kayak cart. An extra set of wheels would be $10, and 3 additional inches of wheel width and overall cart width.

Anybody have good suggestions about where to buy pool noodles this time of year in SD? Suggestions other than Walmart are greatly appreciated...
pbb is offline   Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


All times are GMT -8. The time now is 03:55 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
© 2002 Big Water's Edge. All rights reserved.