Share Your Innovations - Kayak Fishing Adventures on Big Water’s Edge

jorluivil · 03-02-2014, 05:39 PM

You could have gone out and bought a high back seat and got rid of that POS Hobie seat.........that's what I did.

Carp · 03-04-2014, 05:37 PM

Tools needed
1/4 20 tap
#7 drill optional (just go slow w/tap as the hole is a bit tight)
1/4 pan head screw

On the underside of the ram mount there is a hole mine measured .198

Tap hole Using the 1/4 20 tap

You will end up with this

Which you then can use with a mighty mount
I do not have any geartrac but I'm sure it could work with it as well

It's not as pretty as a screwball but it's cheaper and still retains it's original purpose

03-02-2014, 05:39 PM	#1
jorluivil Senior Member Join Date: Apr 2010 Posts: 6,856	You could have gone out and bought a high back seat and got rid of that POS Hobie seat.........that's what I did. __________________ www.facebook.com/Teamsewer

03-04-2014, 05:37 PM	#2
Carp (⌐■_■)--︻╦╤─ - - - Join Date: Jun 2013 Location: Sandy Eggo Posts: 166	Ram ball mod Tools needed 1/4 20 tap #7 drill optional (just go slow w/tap as the hole is a bit tight) 1/4 pan head screw On the underside of the ram mount there is a hole mine measured .198 Tap hole Using the 1/4 20 tap You will end up with this Which you then can use with a mighty mount I do not have any geartrac but I'm sure it could work with it as well It's not as pretty as a screwball but it's cheaper and still retains it's original purpose __________________ "California.. If it's not illegal it's going to cost ya" -Bob Munden

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode