Kayak Fishing Adventures on Big Water’s Edge  

Go Back   Kayak Fishing Adventures on Big Water’s Edge > Kayak Fishing Forum - Message Board > General Kayak Fishing Discussion

Reply
 
Thread Tools Display Modes
Old 04-18-2014, 06:59 PM   #1
bosshoss
Senior Member
 
bosshoss's Avatar
 
Join Date: Mar 2012
Location: Santee
Posts: 197
Quote:
Originally Posted by ful-rac View Post
I think it was 120, call andy at OEX and make sure.
Thanks Tony.....
bosshoss is offline   Reply With Quote
Old 04-18-2014, 07:35 PM   #2
driftwood
Senior Member
 
driftwood's Avatar
 
Join Date: Feb 2009
Location: SAN DIEGO
Posts: 1,086
Oh ok got it.

That mikey, pissing against the wind! I can't wait to see him again and bust him. Whats wrong with that boy!
driftwood is offline   Reply With Quote
Old 04-19-2014, 02:28 PM   #3
Rambo
Senior Member
 
Rambo's Avatar
 
Join Date: Aug 2011
Location: West Covina, CA
Posts: 434
I like to know when was the last time you replace any parts on the mirage drive? Also how many days you put on the mirage drive before any failure occur. Kinda want to gage the factor of repair before I start buying parts to keep in the kayak. Or if anyone can help with these answers. 1st time owning a hobie.
Rambo is offline   Reply With Quote
Old 04-19-2014, 04:37 PM   #4
ful-rac
Emperor
 
ful-rac's Avatar
 
Join Date: May 2009
Location: Buena Park
Posts: 3,649
Quote:
Originally Posted by Rambo View Post
I like to know when was the last time you replace any parts on the mirage drive? Also how many days you put on the mirage drive before any failure occur. Kinda want to gage the factor of repair before I start buying parts to keep in the kayak. Or if anyone can help with these answers. 1st time owning a hobie.
My mirage drive is about 3 years old, first time i replaced the masts. I broke one of the crank arms, idler pulley, changed out the drive cables, idler cable, changed out the drums....and thats about it. I use it at least once or twice a week.

As far as failure of parts...you just never know. It could happen at any time, to anyone. Anybody that has a used drive and you dont know the history of ...would make me nervous. Its expensive but a good investment. You never know when you can help yourself or someone else with a critical spare part.

To any other PA owners out there that only go fishing with a half a paddle....do yourself a favor and take the other half...otherwise your up shit creek with....only half a paddle...you know 1 legged man in an ass kickn contest....you get the picture.

Yes PAs are hard to paddle...but if your drive breaks....its your only way of getting home under your own power.
__________________
There's nothing colder than yesterday's hotdog.
ful-rac is offline   Reply With Quote
Old 04-19-2014, 05:00 PM   #5
jorluivil
Senior Member
 
jorluivil's Avatar
 
Join Date: Apr 2010
Posts: 6,856
Quote:
Originally Posted by ful-rac View Post
My mirage drive is about 3 years old, first time i replaced the masts. I broke one of the crank arms, idler pulley, changed out the drive cables, idler cable, changed out the drums....and thats about it. I use it at least once or twice a week.

As far as failure of parts...you just never know. It could happen at any time, to anyone. Anybody that has a used drive and you dont know the history of ...would make me nervous. Its expensive but a good investment. You never know when you can help yourself or someone else with a critical spare part.

To any other PA owners out there that only go fishing with a half a paddle....do yourself a favor and take the other half...otherwise your up shit creek with....only half a paddle...you know 1 legged man in an ass kickn contest....you get the picture.

Yes PAs are hard to paddle...but if your drive breaks....its your only way of getting home under your own power.
The failure of the drive components is very unpredictable. As an example, I had the drive on my previous kayak for four years and all I replaced were the cables, the idler pulley and a shaft. Tony, he replaced damn near every part in less time. I carry spare cables and a few feet of Dacron just in case my rudder line snaps......... better safe than sorry.
__________________


www.facebook.com/Teamsewer
jorluivil is offline   Reply With Quote
Old 04-19-2014, 11:27 PM   #6
Rambo
Senior Member
 
Rambo's Avatar
 
Join Date: Aug 2011
Location: West Covina, CA
Posts: 434
Thanks for the great feedback and knowledge of the mirage drive guys. From a product perspective the mirage drive should not fail within the first year unless operator error or misuse. But considering the fact you went on 3 years on a used mirage drive that tells me the rate of failure should be very low. So it's safe to say after 2 years of usage its good to start having some extra parts in case of some faultiness with the mirage drive. And for those who does not maintenance their drive I would say you guys should be keeping some spare parts within the first year. Also if your not mechanically incline to disassemble and reassemble the drive buy an extra set and leave that in your car. This would be my opinion on a product that will see failure due to wear and tear but with proper maintenance I could see the product lasting 4 years without major components replacement.
Rambo is offline   Reply With Quote
Old 04-20-2014, 05:54 AM   #7
roadx
.
 
roadx's Avatar
 
Join Date: May 2010
Posts: 1,155
curious if you even tried to remove the flipper and just use the one pedal?
sometime you have to do, what you have to do
having a back up plan either spare parts or a paddle is always smart.
__________________
roadx is offline   Reply With Quote
Old 04-20-2014, 06:15 AM   #8
ful-rac
Emperor
 
ful-rac's Avatar
 
Join Date: May 2009
Location: Buena Park
Posts: 3,649
Quote:
Originally Posted by Rambo View Post
Thanks for the great feedback and knowledge of the mirage drive guys. From a product perspective the mirage drive should not fail within the first year unless operator error or misuse. But considering the fact you went on 3 years on a used mirage drive that tells me the rate of failure should be very low. So it's safe to say after 2 years of usage its good to start having some extra parts in case of some faultiness with the mirage drive. And for those who does not maintenance their drive I would say you guys should be keeping some spare parts within the first year. Also if your not mechanically incline to disassemble and reassemble the drive buy an extra set and leave that in your car. This would be my opinion on a product that will see failure due to wear and tear but with proper maintenance I could see the product lasting 4 years without major components replacement.
Quote:
But considering the fact you went on 3 years on a used mirage drive that tells me the rate of failure should be very low. So it's safe to say after 2 years of usage its good to start having some extra parts in case of some faultiness with the mirage drive.

No, my mirage drive was brand new when i got it. It did not fail for the first time last week. Its failed rarely but it has failed every once and awhile throughout the time i have owned it.

You shouldnt assume anything will be fine after 2 years. Consider it like having a spare tire for your car or a patch kit. Sure you just bought new tires today but its possible that you could get a flat tomorrow...for what ever reason. Now would you leave the spare at home because you got a new set?

My situation i should have known better and had spare parts....

So basically, i got a flat and i didnt buy a spare, so i had to push my car home, up hill on sand....
__________________
There's nothing colder than yesterday's hotdog.
ful-rac is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


All times are GMT -8. The time now is 04:35 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
© 2002 Big Water's Edge. All rights reserved.