magnetic fish finder mounts for transducer - Kayak Fishing Adventures on Big Water’s Edge

taggermike · 04-19-2015, 07:10 AM

Looks like simple time saving solution. No holes needed and if you have several kayaks it would take just seconds to swap the off over. The mount does show a decent profile and distance from the hull so maybe launching could be an issue and kelp would be a serious drag, literally. I was picturing the something dropping down off the bottom of the yak. But the video shows it mounted on the side. Good idea. If the inner mount was strapped on all you'd have to do is set the outside mount and go. And if you needed to clear kelp just reach over the side a few inches. Great idea. Mike

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

04-19-2015, 07:10 AM	#6
taggermike Senior Member Join Date: May 2007 Location: Chula Vista Posts: 1,589	Looks like simple time saving solution. No holes needed and if you have several kayaks it would take just seconds to swap the off over. The mount does show a decent profile and distance from the hull so maybe launching could be an issue and kelp would be a serious drag, literally. I was picturing the something dropping down off the bottom of the yak. But the video shows it mounted on the side. Good idea. If the inner mount was strapped on all you'd have to do is set the outside mount and go. And if you needed to clear kelp just reach over the side a few inches. Great idea. Mike