Over the Side Transducer Mounts? - Kayak Fishing Adventures on Big Water’s Edge

Autrout · 02-02-2016, 07:47 PM

I just purchased a dragonfly at Christms. I am using pvc over the side. I used a foam plug into the Outback cup holder. I compress the foam with big washers and a nut. The bolt is a couple inches longer than flush so i drilled a hole is a cutting board and slide it onto the bolt. I used butterfly nut to tighen the cutting board to the foam insert and hobie deck. I then mounted the FF display to the cutting board. The over the side arm is locked with a removable pin so when not using the FF, i rotate the arm 90 degrees and out of the water. I can sent you pics if you want.

Good luck

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

02-02-2016, 07:47 PM	#7
Autrout Junior Join Date: Jun 2009 Posts: 12	I just purchased a dragonfly at Christms. I am using pvc over the side. I used a foam plug into the Outback cup holder. I compress the foam with big washers and a nut. The bolt is a couple inches longer than flush so i drilled a hole is a cutting board and slide it onto the bolt. I used butterfly nut to tighen the cutting board to the foam insert and hobie deck. I then mounted the FF display to the cutting board. The over the side arm is locked with a removable pin so when not using the FF, i rotate the arm 90 degrees and out of the water. I can sent you pics if you want. Good luck