GearTrack Ram ball?

[jorluivil]

Originally Posted by Raskal311

Does anyone have an issue with the ball spinning loose since there is only one center screw holding it? I installed on directly on to my Pro angler side board and found that it spins loose. I'm planning to put on some lock tight but i'm not sure if that enough. Any ideas on how to keep it from coming loose? Anyone have the same issue using it on a gear track?

I have two installed on my PA and I've never had them come loose. I do recall tightening the bolt as tight as possible but I do not recall whether or not I used Locktite.

[alanw]

In addition to the other comments, consider using the 1-1/2" ball for rods. The 1" seems good for cameras and just adequate for fishfinders.