3D Printed Parts - Kayak Fishing Adventures on Big Water’s Edge

BIG JOAQUIN · 04-06-2016, 10:15 PM

Be mindful of your print/build direction and the loads that may be applied to your parts.

Nylon12 and ABS should work well for most parts, check out ultem if you need something that can handle higher temps.

Transducer mount is a great item to print to suit your needs. I had to cut off a section of my transducer mount to fit my lowrance transducer.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

04-06-2016, 10:15 PM	#17
BIG JOAQUIN Member Join Date: Jan 2016 Location: C'mont Posts: 33	Be mindful of your print/build direction and the loads that may be applied to your parts. Nylon12 and ABS should work well for most parts, check out ultem if you need something that can handle higher temps. Transducer mount is a great item to print to suit your needs. I had to cut off a section of my transducer mount to fit my lowrance transducer.