2011 Pro Angler W/ Outboard

[driftwood]

NiCE!!

Quick question. On the water, How would you remove the kelp once it gets wrapped around the prop.

[blazian]

Little confused, it looks like a Motor Guide trolling motor but you have it listed with a gas 2 stroke?

[MaclarenM]

Originally Posted by blazian

Little confused, it looks like a Motor Guide trolling motor but you have it listed with a gas 2 stroke?

Yes, sorry that was stage one.. I wasn't impressed with the performance of a 55lb motor guide w/ 100lb battery on board so I opted for a 24lb outboard. A new photo is posted just for you

Thanks for looking
Tight lines

[Tarpon]

HOW MUCH CRUST DOES IT HAVE

[MaclarenM]

Originally Posted by Tarpon

HOW MUCH CRUST DOES IT HAVE

HAHAHA it has some fish mojo and may smell a bit if you sniff up close. Havent bleached her for sale or anything.. Its been 2 months sense ive been out.. but all is functional. I rinsed her after each use, but it is a 2011

[MaclarenM]

Originally Posted by Tarpon

are you sure you rinsed it bc i had a buddy just come check it out and drive was all rusted and crust everywhere

You do realize its 2016 right? It was manufactured 5 years ago and its is well used. Its spent 4-10 hours on the water each use. Im also not sure if you realize, just about EVERYTHING will rust, fade, or deteriorate in saltwater. Im sorry if your that butthurt you & your buddy couldn't manage the courage to give a counter offer, or had the brains to realize it was a 2011 model.

Seeing that you have to pathetically share your misfortunes and discontent on the internet shows, you have some deeper issues bud. good luck.

[blazian]

Ok thanks for claryfing with the photo! How fast can you go with that outboard?

[MaclarenM]

Originally Posted by driftwood

NiCE!!

Quick question. On the water, How would you remove the kelp once it gets wrapped around the prop.

Well if u were so inclined to drive into a kelp paddy with a 3.5h motor with a 4inch prop , ur asking for it. It controls like a dream at trolling speeds I've split the paddy's at the jewel. Some fellas have seen it in action. Peir to Point in 7-10 mins.

The motor swivels up , a little ingenuity and a gaff would do just fine..
Or if u were wearing ur steel balls, just jump in and get wet lol.

Only had this issue once, after a YT fight and with reverse and forward gears I was able to break it off and motor away - minus my fish he cut me off down low in the thick shit

Thanks for looking
Tight lines