Looking for install ideas - Dragon Fly 7

[goldenglory18]

Originally Posted by CrazzyGar

On which Kayak...?

That will make a difference.

Sent from my iPhone using Tapatalk

Fair point.... 2016 Ride 135. No rudder, no in-scupper option for 'ducer (the Raymarine transducer is HUGE.)

Originally Posted by GTboosted

If you don't have a rudder don't put it over the side. I had an arm on mine and it created enough drag that it needed slight paddling correction. Luckily I had a rudder on my old tarpon 140.

Under water is your best option. Now I have a lowrance ready kayak but my next move on the tarpon would have been to install the ducer in a scupper hole closer to the front. That way it doesn't get damaged when I drag the kayak.

I see a bunch of people waste time on battery boxes. Imo they are not needed. Just clean an lube the plugs.

Hmmm, not sure why it would cause THAT much drag, but it makes sense.

The battery box is a must when you have a less-than sealed hull.

[GTboosted]

It wasn't that much but enough to be annoying. Enough that I was going to redo it. Lol


As far as the battery box goes, it all depends on how much water you planning on taking in. My cheap $10 12v 9ah batteries are fully sealed and sometimes sit in water in my PA. In my tarpon, they would sometimes sit in a inch or two of water after rolling in the surf with no issues. Never even blew the inline fuse either.

[Dave Legacy]

I use a ram arm and it makes a little noise, but less than my paddling. Also, the drag is there, but not enough to bother me - I bring up the arm when I'm focused on reaching a destination anyway. The ram arm isn't ideal, but it meets my realistic expectations of it.

[Amish Ed]

I've been using a Madfrog TDA since they came out (long before they were in my signature). On my Ride I have the TDA on the track mount, the battery goes in a drybag in the footwell with the extra transducer cable, and the head unit is on a Ram mount above the cup holder.

I have a rudder now, but this is the first time I've had one. Drag is negligible. If on a really long paddle, I too just flip it up.

The way I have mine setup is obviously not good for beach launching, but I never surf launch. So, it's a non-issue. If I did regular surf launches I'd move the battery and extra cable inside the yak.