Don't try this - Kayak Fishing Adventures on Big Water’s Edge

dsafety · 07-27-2009, 09:23 PM

Looks like a great design with lots of potential. If I were building it, I would use 2" ABS rather than PVC and run a line or cable from the anchor point on the bike through the pipe to a place near the wheels. I would put some tension on the cable so it becomes kind of an internal safety strap.

If you can identify some places that tend to flex too much, just cut a larger piece of pipe in half and glue it to the flex points.

You have two flex points that, unless you figure out how to brace them, will always be a problem. They are at the seat and at the 45 degree angle over wheel. You could create a different kind of connection at the seat that pivioted up and down as well as right and left. The 45 degree connection needs to be really beefed up. I bet that is where the thing broke.

Bob

Matt · 07-27-2009, 09:33 PM

Two words ......DUCT TAPE!!!

07-27-2009, 09:33 PM	#2
Matt Support your local pangas Join Date: Feb 2007 Location: Lj Posts: 976	Two words ......DUCT TAPE!!! __________________ Thanks Matt F.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

07-27-2009, 09:23 PM	#1
dsafety Olivenhain Bob Join Date: May 2008 Location: Olivenhain, CA Posts: 1,123	Looks like a great design with lots of potential. If I were building it, I would use 2" ABS rather than PVC and run a line or cable from the anchor point on the bike through the pipe to a place near the wheels. I would put some tension on the cable so it becomes kind of an internal safety strap. If you can identify some places that tend to flex too much, just cut a larger piece of pipe in half and glue it to the flex points. You have two flex points that, unless you figure out how to brace them, will always be a problem. They are at the seat and at the 45 degree angle over wheel. You could create a different kind of connection at the seat that pivioted up and down as well as right and left. The 45 degree connection needs to be really beefed up. I bet that is where the thing broke. Bob