How to load and unload an outback? - Kayak Fishing Adventures on Big Water’s Edge

lbsurf2ca · 10-13-2011, 11:02 AM

1. I always put it on one rail then move towards the tail
2. When i reach the tail flip it upside down
4. start lifting it up while having the nose still on the ground.
3. Once i reach the middle where the handle is i bring it over my head and onto my roof.

I have an SUV which is pretty tall.

I found side to shoulder method was starting to irritate my shoulder. Once I started using the other method i haven't had any bruises or pain.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

10-13-2011, 11:02 AM	#7
lbsurf2ca Senior Member Join Date: Sep 2010 Location: Encinitas Posts: 395	1. I always put it on one rail then move towards the tail 2. When i reach the tail flip it upside down 4. start lifting it up while having the nose still on the ground. 3. Once i reach the middle where the handle is i bring it over my head and onto my roof. I have an SUV which is pretty tall. I found side to shoulder method was starting to irritate my shoulder. Once I started using the other method i haven't had any bruises or pain.