Share Your Innovations

[jorluivil]

I decided to replace my Hobie Stock P.O.S Seat so I contacted Andy @ OEX, asked for a price and recommendation, got an answer back in no time and paid him a visit. Ended up purchasing the last last years years model Pacific Anglers seat, as always, Andy took care of me.

After looking at the structure of the old seat and the new one I chose to not use the standard pegs that the Hobie seats come with. Since the PA seat is not made to accept these pegs I would have had to drill/cut into the new seat, the problem with this idea is that the area where the plugs would have placed is not sturdy, there is a great chance I would have damage the integrity of the seat, maybe not now but definitely over time.

First step and the most obvious was to remove the stock seat




Step 2

Mount the bait tank and check the surrounding area to make sure that I have space for the eyelets mounts without affecting the installation of the bait tank and the buckles for the seat




Step 3

Drill, goop and rivet eyelets that will receive the rear buckles




Step 4

Adjust seat, make sure everything fits and load car for fishing tomorrow