F/F recommendations w/o side scan

[blazian]

Originally Posted by Baja_Traveler

I'm not going to put any hole in at all (excluding the screw holes for the mounting plate). I'll center the transducer mounting plate on one of the bottom channels in front of the motor well in clean water, then run the cable back in the channel, and up to an above water bulkhead fitting using screw down cable ties. Because the plate will be centered on the channel, I can't use the front screw-down location intended for the Hobie, so I'll add several on the sides - going from a three screw arrangement to a four screw one.

OK I see now. thanks