Kayak Fishing Adventures on Big Waterís Edge  

Go Back   Kayak Fishing Adventures on Big Waterís Edge > Kayak Fishing Forum - Message Board > General Kayak Bass Fishing Discussion

Reply
 
Thread Tools Display Modes
Old 06-21-2018, 05:06 AM   #1
Yakitman
Junior
 
Join Date: Jun 2018
Posts: 1
Yak repair

My scrubber pro kayak slipped out of its tie downs and was dragged down the freeway a little. The rear keel was ground down at a 45 degree angle. A lot odf materal was removed but no hole. Can i build it up with plasic weld or some other material? I just got the kayak last week any help would be appreciated. Thamk you
Yakitman is offline   Reply With Quote
Old 06-21-2018, 03:10 PM   #2
Iceman
Senior Member
 
Iceman's Avatar
 
Join Date: Mar 2005
Location: 1-2 miles off the point
Posts: 6,618
If there is no hole and not scary thin, just leave it as is and keep an eye on it for any additional wear. sometimes attempting to weld thin plastic creates a big problem. You could apply an adhesive keel guard or even JB Weld to give you a wear indicator.
__________________
Iceman is offline   Reply With Quote
Old 06-21-2018, 05:34 PM   #3
Master-baiter
Member
 
Master-baiter's Avatar
 
Join Date: Sep 2017
Posts: 52
Can try the gator guard to add a layer and protect that area. Iíve used this on my kayak and itís rock solid.

https://www.gator-guards.com


Sent from my iPhone using Tapatalk
Master-baiter is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -8. The time now is 12:47 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
© 2002 Big Water's Edge. All rights reserved.