PVC rod holders for hobie? - Kayak Fishing Adventures on Big Water’s Edge

lowprofile · 11-13-2012, 10:03 PM

this weeks project will be rod holders for the PA. just ones to keep them upright while not in use. plan is to fit a piece of pvc or abs into the existing rod holders in the rear then get an elbow and run 2" pipe straight back with 3 T sections on each side with 14" of pipe going straight up to hold the rods. put a 90 on the end and connect the two sides with pipe going across the back. should easily be held in place by the bungee straps back there and keep the deck open for the bait tank (which will not accept rod holders due to the way the sides are slanted) and fish.

has anyone done something similar and know which size pipe fits the rod holders?

11-13-2012, 10:03 PM	#1
lowprofile #1 on fishstick's hitlist Join Date: May 2011 Location: Sea level Posts: 1,477	PVC rod holders for hobie? this weeks project will be rod holders for the PA. just ones to keep them upright while not in use. plan is to fit a piece of pvc or abs into the existing rod holders in the rear then get an elbow and run 2" pipe straight back with 3 T sections on each side with 14" of pipe going straight up to hold the rods. put a 90 on the end and connect the two sides with pipe going across the back. should easily be held in place by the bungee straps back there and keep the deck open for the bait tank (which will not accept rod holders due to the way the sides are slanted) and fish. has anyone done something similar and know which size pipe fits the rod holders? __________________ MLPA- My Largest Poaching Area