Share Your Innovations

[StinkyMatt]

So using your "FUZZY" logic your 40 incher really measured out at 36.5 inches. I win!!!!!!!!



Now show us all how you calibrate your scale?

[kobra]

Originally Posted by StinkyMatt

So using your "FUZZY" logic your 40 incher really measured out at 36.5 inches. I win!!!!!!!!



Now show us all how you calibrate your scale?

That's easy Matt, just get a ten pound basket and put your fish in it.

[echo1er]

Well I tried
http://www.youtube.com/watch?v=ZaUDEY6zRUU

[jorluivil]

Originally Posted by echo1er

Well I tried
http://www.youtube.com/watch?v=ZaUDEY6zRUU

Why not use one long sticker and cut it where the paddle separates? Bring me your paddle......I'll hook you up with a sticker that is sure to get you so many legals you won't know what to do with all the fish.

[Regor]

Taking the example from Walrus, I wanted to take it one step furthur for the ease of filling it with water and to make it a little more secure.

The terminal box is from just about any DIY hardware store. I purchased all my materials from Marshals on 8423 Production Ave (at Miramar Rd). They have every bit of hardware you will need, from Termial box to stainless hardware and stainless/rubber washers.


Purchase your terminal box so it is just big enough to hold your ducer. Accuracy in drilling the holes is crucial to maintaining a parallel ducer install, both left and right, and up and down so the ducer sits parallel to the bottom of your yak.

I wanted an easy way to fill the ducer holder with water, so I drilled a hole in the sail mast. This enabled a refill at any time (although I have noticed "0" water loss). The terminal box sits right against the sail mast, so the mast also serves as something stable to secure the terminal box against.

The initial results are great. I can following a jig all the way up/down past 100', and watch it as it sits there 10' above the bottom : )


.
.
.
The ducer sitting in the terminal box

.
.


The sail mast removal

.
.

The install

.
.

The final product

.
.

[bellcon]

Very clean


not sure it matters, but isn't your transducer in backwards now ?

[Regor]

Originally Posted by bellcon

Very clean


not sure it matters, but isn't your transducer in backwards now ?

I just go in reverse all day

*** Results may differ based on your Transducer ***
*** I have a Lowrance ***

Based on the techies over at Lowrance, the transducer I have is strictly 2D. It does not matter if I put it in as you would mount a Transom mount (facing to the back), or 180 degrees (backwards). As long as it is parallel to the bottom and sides, and you are shooting straight down, you will get a good picture and arches.

[bus kid]

Originally Posted by kobra

That's easy Matt, just get a ten pound basket and put your fish in it.

baawwaaahhhhaaaa, so that's how all you guys have been posting in the 50+ thread.