Kayak Fishing Adventures on Big Water’s Edge  

Go Back   Kayak Fishing Adventures on Big Water’s Edge > Kayak Fishing Forum - Message Board > General Kayak Fishing Discussion

Reply
 
Thread Tools Display Modes
Old 08-29-2017, 11:28 AM   #1
goldenglory18
Senior Member
 
goldenglory18's Avatar
 
Join Date: Feb 2015
Location: Seattle Area
Posts: 861
Looking for install ideas - Dragon Fly 7

All,

I'm preparing to buy all the required stuff to install my Dragon Fly 7pro, and looking for some inspiration. Anyone have some favorite projects they have seen/tried/referenced that you'd like to share?

Here is what I'm considering:

*Wet, over the gunnel ducer install. Possibly RAM, possibly DIY. No Scotty.
*Track mount + RAM arm screen mount. 1" should work
*Simple drybox battery, but setup for either home or auto 12v charging
*Blue Sea Systems wire and cable management

Any and all ideas/suggestions are appreciated!

goldenglory18 is offline   Reply With Quote
Old 08-29-2017, 11:38 AM   #2
CrazzyGar
Senior Member
 
CrazzyGar's Avatar
 
Join Date: Sep 2011
Location: Rancho Cucamonga, Ca.
Posts: 177
Quote:
Originally Posted by goldenglory18 View Post
All,



I'm preparing to buy all the required stuff to install my Dragon Fly 7pro, and looking for some inspiration. Anyone have some favorite projects they have seen/tried/referenced that you'd like to share?



Here is what I'm considering:



*Wet, over the gunnel ducer install. Possibly RAM, possibly DIY. No Scotty.

*Track mount + RAM arm screen mount. 1" should work

*Simple drybox battery, but setup for either home or auto 12v charging

*Blue Sea Systems wire and cable management



Any and all ideas/suggestions are appreciated!





On which Kayak...?

That will make a difference.


Sent from my iPhone using Tapatalk
CrazzyGar is offline   Reply With Quote
Old 08-29-2017, 12:04 PM   #3
GTboosted
Senior Member
 
Join Date: Jul 2014
Location: Lake Balboa, The Valley
Posts: 425
If you don't have a rudder don't put it over the side. I had an arm on mine and it created enough drag that it needed slight paddling correction. Luckily I had a rudder on my old tarpon 140.

Under water is your best option. Now I have a lowrance ready kayak but my next move on the tarpon would have been to install the ducer in a scupper hole closer to the front. That way it doesn't get damaged when I drag the kayak.

I see a bunch of people waste time on battery boxes. Imo they are not needed. Just clean an lube the plugs.
__________________
-Beto
GTboosted is offline   Reply With Quote
Old 08-29-2017, 12:37 PM   #4
goldenglory18
Senior Member
 
goldenglory18's Avatar
 
Join Date: Feb 2015
Location: Seattle Area
Posts: 861
Quote:
Originally Posted by CrazzyGar View Post
On which Kayak...?

That will make a difference.

Sent from my iPhone using Tapatalk
Fair point.... 2016 Ride 135. No rudder, no in-scupper option for 'ducer (the Raymarine transducer is HUGE.)

Quote:
Originally Posted by GTboosted View Post
If you don't have a rudder don't put it over the side. I had an arm on mine and it created enough drag that it needed slight paddling correction. Luckily I had a rudder on my old tarpon 140.

Under water is your best option. Now I have a lowrance ready kayak but my next move on the tarpon would have been to install the ducer in a scupper hole closer to the front. That way it doesn't get damaged when I drag the kayak.

I see a bunch of people waste time on battery boxes. Imo they are not needed. Just clean an lube the plugs.
Hmmm, not sure why it would cause THAT much drag, but it makes sense.

The battery box is a must when you have a less-than sealed hull.
goldenglory18 is offline   Reply With Quote
Old 08-29-2017, 01:12 PM   #5
GTboosted
Senior Member
 
Join Date: Jul 2014
Location: Lake Balboa, The Valley
Posts: 425
It wasn't that much but enough to be annoying. Enough that I was going to redo it. Lol


As far as the battery box goes, it all depends on how much water you planning on taking in. My cheap $10 12v 9ah batteries are fully sealed and sometimes sit in water in my PA. In my tarpon, they would sometimes sit in a inch or two of water after rolling in the surf with no issues. Never even blew the inline fuse either.
__________________
-Beto
GTboosted is offline   Reply With Quote
Old 08-29-2017, 01:22 PM   #6
Dave Legacy
Senior Member
 
Dave Legacy's Avatar
 
Join Date: Mar 2015
Location: Hacienda Heights, CA
Posts: 427
I use a ram arm and it makes a little noise, but less than my paddling. Also, the drag is there, but not enough to bother me - I bring up the arm when I'm focused on reaching a destination anyway. The ram arm isn't ideal, but it meets my realistic expectations of it.
Dave Legacy is offline   Reply With Quote
Old 08-29-2017, 03:20 PM   #7
Amish Ed
Senior Member
 
Amish Ed's Avatar
 
Join Date: Jun 2005
Location: Grants Pass, OR
Posts: 1,903
I've been using a Madfrog TDA since they came out (long before they were in my signature). On my Ride I have the TDA on the track mount, the battery goes in a drybag in the footwell with the extra transducer cable, and the head unit is on a Ram mount above the cup holder.

I have a rudder now, but this is the first time I've had one. Drag is negligible. If on a really long paddle, I too just flip it up.

The way I have mine setup is obviously not good for beach launching, but I never surf launch. So, it's a non-issue. If I did regular surf launches I'd move the battery and extra cable inside the yak.
__________________
Amish Ed
You can't catch it again if it's dead!
Amish Ed is offline   Reply With Quote
Old 08-29-2017, 04:36 PM   #8
StumpFisher
Member
 
Join Date: Sep 2016
Location: Riverside
Posts: 52
For battery options I picked up a lithium nocqua power pro battery. A little more expensive than the classic bricks but is all self contained with water proof attachment to FF provided and is super small/light weight which I love. They have 4.4 AH and 10AH and since I don't have a livewell I can get away with just the 4.4 AH for my FF. Haven't done a full day yet but rated to be able to handle 6-8 hours for FF alone. $80 on sale on Austin kayak right now. The 10AH is $130.
StumpFisher is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


All times are GMT -8. The time now is 04:33 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
© 2002 Big Water's Edge. All rights reserved.