PDA

View Full Version : Yak repair


Yakitman
06-21-2018, 05:06 AM
My scrubber pro kayak slipped out of its tie downs and was dragged down the freeway a little. The rear keel was ground down at a 45 degree angle. A lot odf materal was removed but no hole. Can i build it up with plasic weld or some other material? I just got the kayak last week any help would be appreciated. Thamk you

Iceman
06-21-2018, 03:10 PM
If there is no hole and not scary thin, just leave it as is and keep an eye on it for any additional wear. sometimes attempting to weld thin plastic creates a big problem. You could apply an adhesive keel guard or even JB Weld to give you a wear indicator.

Master-baiter
06-21-2018, 05:34 PM
Can try the gator guard to add a layer and protect that area. Iíve used this on my kayak and itís rock solid.

https://www.gator-guards.com


Sent from my iPhone using Tapatalk