Finished my kage. - Kayak Fishing Adventures on Big Water’s Edge

MrPatrick · 03-08-2013, 09:08 PM

Just made one too. Mine is made from a golf club shaft and a 24" long 3/8" piece of threaded rod. Warped the rod with electrical tape and used a nut to cinch it down in the club shaft. Also used some rubber screw in chair feet as a way to cushion the end of the cut golf shaft. Has a good feel in the hand. Maybe ten inches of thread exposed. Just need to put a chisel point in it.

03-08-2013, 09:08 PM	#14
MrPatrick Senior Member Join Date: Jul 2007 Location: Waiting to launch Posts: 1,381	Kage Just made one too. Mine is made from a golf club shaft and a 24" long 3/8" piece of threaded rod. Warped the rod with electrical tape and used a nut to cinch it down in the club shaft. Also used some rubber screw in chair feet as a way to cushion the end of the cut golf shaft. Has a good feel in the hand. Maybe ten inches of thread exposed. Just need to put a chisel point in it.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode