Gaff length?

[Law Hand]

Lets see this SESSAGAFF. I see you posting on all the forums but no pics.

[SESSAGAFF]

got a bomb ass new camera to so ill have better pics for ya

[-scallywag-]

do you really need a gaff to land big fish??? unless im fishing deep in the kelp or for hali's, i leave the extendo gaff at home...i like the challenge and the safety of not having a gaff onboard, i like handling the fish, gently removing the hook and letting them go, or when i do catch that trophey grab it by the gills, slam it on the deck, get it in a figure4 and rip its gills out (big hali;s being the exception)....as for the safety part just look at all those gaffs in the tournament wipe-out photos....scary.

[dorado50]

I have brought in both a wsb and yt by the gills and don't ever want to do it again. Really rakes the hands,ok for the moment but next few days not so cool. Not being a fan of long gaffs,I opt for shorter ones,no more than 24" and I perfer the 18" one. Large and long gaffs are a minus imo, just another item to help in the loss of a fish. A shorter gaff gives one much more control over the situation and does not hinder you by getting in the way. Having a gaff on board without a point protecter(rubber tip,cork,whatever)is just plain stupid.Some guys are out there waiting for an accident to happen......

[Law Hand]

Got tired of waiting, went into garage fired up the HAAS Lathe and made this.

Yes its TITANIUM (shaft, cap, and hook), yes it floats, yes it will never corrode, yes it can be made in just about any length.

http://i375.photobucket.com/albums/o...971/GAFF04.jpg


http://i375.photobucket.com/albums/o...971/GAFF03.jpg


http://i375.photobucket.com/albums/o...971/GAFF02.jpg

[dorado50]

Why would you need lathe? The only way to make this would be, trepan a given diameter or weld titanium sheet. How could this possibly float if you grind ,or use lathe,a solid bar down to smaller dia.???? A solid ti bar is light but will not float! Want to refigure your process and or story so that at least I could understand and hopefully learn something new,thanks.

[Law Hand]

Its a tube, the caps are turned and threaded; as well as turning the tip on the hook. I also used a fixture to bend the hook. ( I have a lathe, just thought I would have some fun and put it to good use)

[dgax65]

Originally Posted by dorado50

Why would you need lathe? The only way to make this would be, trepan a given diameter or weld titanium sheet. How could this possibly float if you grind ,or use lathe,a solid bar down to smaller dia.???? A solid ti bar is light but will not float! Want to refigure your process and or story so that at least I could understand and hopefully learn something new,thanks.

It is a good thing that an expert like Dave is all over this topic. I would hate for anybody to mislead the kayak fishing public about the properties or construction of a titanium gaff. The last thing we need to have in our community is somebody misrepresenting a substandard or non-conforming gaff as a true titanium gaff. That would be terribly unethical. I don't think you could get indicted for something like that, but it is wrong. Thanks again Dave for keeping this forum honest.