Revo dilemma - Kayak Fishing Adventures on Big Water’s Edge

StinkyMatt · 12-18-2010, 09:04 PM

Made my rod holders today, the simplest, most useful thing I did to my kayak. Thanks so much for this post.

Do not go too short on the rod holder pipes, try and try twice.

Buy the black pipe at Home Depot.

Used a plastic Perrier bottle to flare the ends.

I used the 1.5in pipe. It is wider and can accomodate a big wide rod blank easier. There is a large amount of material you need to sand/ grind away from the 1.5 pipes, use very coarse paper on your sander (50 or 60) then finish with something finer.

Make sure you sand the PVC if you plan on paining it. Flat black came our bitchin!

Adam12 · 12-19-2010, 06:27 AM

Hey JB would you rather cut the slots in the pipe or sand it down?

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

12-18-2010, 09:04 PM	#1
StinkyMatt Senior Member Join Date: Jun 2010 Location: Under a bridge Posts: 2,169	Made my rod holders today, the simplest, most useful thing I did to my kayak. Thanks so much for this post. Do not go too short on the rod holder pipes, try and try twice. Buy the black pipe at Home Depot. Used a plastic Perrier bottle to flare the ends. I used the 1.5in pipe. It is wider and can accomodate a big wide rod blank easier. There is a large amount of material you need to sand/ grind away from the 1.5 pipes, use very coarse paper on your sander (50 or 60) then finish with something finer. Make sure you sand the PVC if you plan on paining it. Flat black came our bitchin!

12-19-2010, 06:27 AM	#2
Adam12 Senior Member Join Date: Nov 2008 Location: Whittier Posts: 126	Hey JB would you rather cut the slots in the pipe or sand it down?