Kayak Fishing Adventures on Big Water’s Edge  

Go Back   Kayak Fishing Adventures on Big Water’s Edge > Kayak Fishing Forum - Message Board > General Kayak Fishing Discussion

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 01-03-2011, 07:20 PM   #11
GregAndrew
Senior Member
 
Join Date: Mar 2009
Posts: 2,384
I think these are similar to what Tagyak uses to connect his battery to the charger.
http://www.hopkinstowingsolutions.co...extension.html

You cut the wires in half and use one side to connect to your battery and the other side to the FF using simple auto wire connectors on the cut ends. The Sears charger http://www.sears.com/shc/s/p_10153_1...&blockType=G17 has a connector that should connect right to one end (make sure you get the male/female connector polarity correct). Leaving these connectors attached to the tabs on your battery will reduce wear and tear on them too. You can easily use the small alligator clips that come with other chargers on them too.
GregAndrew is offline   Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


All times are GMT -8. The time now is 02:18 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
© 2002 Big Water's Edge. All rights reserved.