Transducer install

[PegLegFury]

the prefered location for me would be centrally located on the bow where the V is narrowest. The other options would be
a little off to either side or
right below the seat where the transducer fits inside the V.

Good looking Jim. Does your 'ducer rest on both sides of the channel with water separating the 'ducer from the hull in the middle?

[maui jim]

I mounted mine in the narrows and its works fine. just make sure its sits level in the hull not tiltin up or down. and goop it good

[PegLegFury]

Originally Posted by maui jim

I mounted mine in the narrows and its works fine. just make sure its sits level in the hull not tiltin up or down. and goop it good

i wasn't going to goop it in place. I was doing a boxless Duct Seal install so I can transfer between kayaks easier. Just putting a circular wall of duct seal down, putting some water inside, lay the 'ducer inside and wrap duct seal over the top of the 'ducer.
I was thinking about a box/tubberware install but those contours would be difficult to shape

[PegLegFury]

Jim, can u describe in detail your install?