Transducer mounting

[Jimmyz123]

Originally Posted by BrokeLoser

I mounted mine in my new PA like the one below. I made a reservoir using the duct seal / putty...set my ducer in middle...folded putty flaps over to hold ducer in place and filled reservoir with water.

Your installation is very much what was done on the video posted below
http://www.youtube.com/watch?v=GEZ9_C1iKP0

I went off of this video posted by a buddy of mine, John Oast. At the end of the video it looks as though he put water in the sponge but I have not done that with my installs.
http://www.youtube.com/watch?v=3u1d3_UeD3k

All I know is the Electrical putty install is the easiest and quickes way to install. Best of all, it works.

[BrokeLoser]

Originally Posted by Jimmyz123

Your installation is very much what was done on the video posted below
http://www.youtube.com/watch?v=GEZ9_C1iKP0

I went off of this video posted by a buddy of mine, John Oast. At the end of the video it looks as though he put water in the sponge but I have not done that with my installs.
http://www.youtube.com/watch?v=3u1d3_UeD3k

All I know is the Electrical putty install is the easiest and quickes way to install. Best of all, it works.

I'll agree, the electrical putty method is definitely the easiest with almost no possibility of error when compared to other methods such as the 'goop' install where you have the unforeseen air bubbles issue.
I should also add; the only reason I used this method was because jimmyZ was such an advocate of it......THANKS JIMMY!