Truck inside camper shell rod carrier - Kayak Fishing Adventures on Big Water’s Edge

tomahawk · 06-23-2014, 10:35 PM

I made something similar to the rod loft and Mrjb's setup. 1x2 oak with holes cut in it with a hole saw. hung from clothes hook in rear of yukon (as shown in rod loft). This end held the rod butts. tips were held up by a string tensioned as high up as possible. ended up rubberbanding tips to string to prevent them from sliding to middle. If I was doing it again I'd make a second wood piece for the tips. no longer used due yukon being totaled while stopped at a red light.

06-23-2014, 10:35 PM	#15
tomahawk Senior Member Join Date: Aug 2012 Posts: 109	I made something similar to the rod loft and Mrjb's setup. 1x2 oak with holes cut in it with a hole saw. hung from clothes hook in rear of yukon (as shown in rod loft). This end held the rod butts. tips were held up by a string tensioned as high up as possible. ended up rubberbanding tips to string to prevent them from sliding to middle. If I was doing it again I'd make a second wood piece for the tips. no longer used due yukon being totaled while stopped at a red light.