3D Printed Parts - Kayak Fishing Adventures on Big Water’s Edge

AirborneYak · 04-06-2016, 03:00 PM

here are the pictures.

AirborneYak · 04-06-2016, 03:01 PM

one more.

Rocketfish · 04-06-2016, 03:37 PM

That's pretty cool Paul, although I wonder why he didn't just use the plexiglass version. In order to make such a plate like he did, one would need the CAD model. I believe that is the hardest part of this whole 3D printing experience.

Rambo · 04-06-2016, 05:09 PM

Looks like it turn out great.

measure, draw, print. voila parts design and printed in less than a few hours.

silentviper · 04-06-2016, 06:49 PM

I've been designing and printing different scotty mounts.

Using this as a base for any attachments: http://www.thingiverse.com/thing:793219, and doing all modeling in Fusion 360.

I've been printing the attachments completely solid after having a 60% solid one fail quite easily.

BIG JOAQUIN · 04-06-2016, 10:15 PM

Be mindful of your print/build direction and the loads that may be applied to your parts.

Nylon12 and ABS should work well for most parts, check out ultem if you need something that can handle higher temps.

Transducer mount is a great item to print to suit your needs. I had to cut off a section of my transducer mount to fit my lowrance transducer.

Lipripper92592 · 04-07-2016, 02:49 PM

Try having the parts laser cut from Acrylic, or HDPE. Acrylic glue will weld the three parts together and will only shatter when hit very hard.

04-06-2016, 03:37 PM	#3
Rocketfish Senior Member Join Date: Mar 2015 Location: North O.C. Posts: 156	That's pretty cool Paul, although I wonder why he didn't just use the plexiglass version. In order to make such a plate like he did, one would need the CAD model. I believe that is the hardest part of this whole 3D printing experience.

04-06-2016, 05:09 PM	#4
Rambo Senior Member Join Date: Aug 2011 Location: West Covina, CA Posts: 434	Looks like it turn out great. measure, draw, print. voila parts design and printed in less than a few hours.

04-06-2016, 06:49 PM	#5
silentviper Member Join Date: Nov 2011 Posts: 41	I've been designing and printing different scotty mounts. Using this as a base for any attachments: http://www.thingiverse.com/thing:793219, and doing all modeling in Fusion 360. I've been printing the attachments completely solid after having a 60% solid one fail quite easily.

04-06-2016, 10:15 PM	#6
BIG JOAQUIN Member Join Date: Jan 2016 Location: C'mont Posts: 33	Be mindful of your print/build direction and the loads that may be applied to your parts. Nylon12 and ABS should work well for most parts, check out ultem if you need something that can handle higher temps. Transducer mount is a great item to print to suit your needs. I had to cut off a section of my transducer mount to fit my lowrance transducer.

04-07-2016, 02:49 PM	#7
Lipripper92592 Senior Member Join Date: Dec 2012 Posts: 516	Try having the parts laser cut from Acrylic, or HDPE. Acrylic glue will weld the three parts together and will only shatter when hit very hard.