Hauling Pro Angler 14??? - Kayak Fishing Adventures on Big Water’s Edge

Hunters Pa · 04-09-2016, 05:39 PM

I was putting it up on top of my Envoy using carpeted 2x4s as bunks to help slide it up there. Started to get too unwieldy so I bought a used jet ski trailer that I am working on.

My back and Achilles are thanking me

RockyRaab · 04-11-2016, 09:19 AM

I've posted these many times, but there are always new guys to the fold, so...

I put a set of Hully rollers on my crossbars, and made up a little wooden ramp to protect my paint and help guide the bow up from the rear:

And I carved a wooden block to fit inside my drive well and prevent any movement of the yak:

Pick up the bow and rest it on the rollers first (This shows my older Durango, but the method is the same)

And then just lift the stern and roll the PA14 forward until the drive well drops over the safety block. Tie down and done:

04-09-2016, 05:39 PM	#1
Hunters Pa Senior Member Join Date: Jul 2006 Location: Fullerton Posts: 1,361	I was putting it up on top of my Envoy using carpeted 2x4s as bunks to help slide it up there. Started to get too unwieldy so I bought a used jet ski trailer that I am working on. My back and Achilles are thanking me

04-11-2016, 09:19 AM	#2
RockyRaab Senior Member Join Date: Mar 2012 Location: Utah Posts: 138	I've posted these many times, but there are always new guys to the fold, so... I put a set of Hully rollers on my crossbars, and made up a little wooden ramp to protect my paint and help guide the bow up from the rear: And I carved a wooden block to fit inside my drive well and prevent any movement of the yak: Pick up the bow and rest it on the rollers first (This shows my older Durango, but the method is the same) And then just lift the stern and roll the PA14 forward until the drive well drops over the safety block. Tie down and done: